Installation; Clock Installation - Bodet Style 5S Hôpital Notice D'installation

II

– Installation

2.1 Clock installation

1) Mounting without back cover
According to the model of the clock make the cut-out following the dimensions listed in table below
Style 5S OP
Style 7S OP
Dimensions in mm
a) Insert the clock in the cut-out in order to mark the position of the 4 mountig screws.
b) Remove the clock and drill 4 holes Ø 6mm to insert the wall plugs.
c) Feed the power cable and the synchronisation cable throught the cut-out
d) Connect the clock, adjust the brightness (refer to page 7) and set the time (refer to page 10).
e) Fix the clock to the wall with the 4 screws Ø4 mm
A B
400
46
440
Installation without back cover
C D
365 68
404 85
EN
E
107
123
5