Publicité
Purge Valve Installation
A gas purge valve is available to protect the pump bearings against
particulate and corrosive gases that could move into the pump.
To install the gas purge valve it is necessary to unscrew the purge
port cover as shown in the following figure,
Figure 39
and then screw the gas purge valve (with a torque of 2.5 Nm) as
shown in the following figure.
Figure 40
TwisTorr 704 FS User Manual / 87-901-051-01 (A)
Technical Information
Purge Valve Installation
17
311/334
Publicité
Chapitres
