Purge Valve Installation - Agilent Technologies TwisTorr 74 FS Notice De Mode D'emploi

Masquer les pouces Voir aussi pour TwisTorr 74 FS:

Les langues disponibles

Technical Information

Purge Valve Installation

A gas purge valve is available to protect the pump bearings against

particulate and corrosive gases that could move into the pump. To

install the gas purge valve it is necessary to unscrew the M12 screw

from the purge port as shown in the following figure;

and then screw the M12 gas purge valve (with a torque of 2.5 Nm).

TwisTorr 74 FS User Manual / 87-901-053-01 (A.00)