Purge Valve Installation - Agilent Technologies TwisTorr 305 FS Notice De Mode D'emploi

Purge Valve Installation

A gas purge valve is available to protect the pump bearings against particulate and
corrosive gases that could move into the pump. To install the gas purge valve it is
necessary to switch off the pump and unscrew the purge port cover as shown in the
following figure.
Figure 41
and then screw the gas purge valve (with a torque of 2.5 Nm) as shown in the
following figure.
Figure 42
TwisTorr 305 FS User Manual / 87-901-057-01 (A.00)
Technical Information

Purge Valve Installation

247/258
8