Technical Data - Migatronic TIG SCOUT 160 HP Manuel D'instructions

Gas connection
Connect the gas hose (6) to the gas system by
means of a gas pressure reducer with flow control.
Fit and secure the gas hose to the gas connection
(7) on the front of the machine.
Usage of the machine
When welding, a heating of various components of
the machine takes place and during breaks these
components will cool down again. It must be ensured
that the flow is not reduced or stopped.
When the machine is set for higher welding currents,
there will be a need for periods during which the
machine can cool down.
The length of these periods depends on the current
setting, and the machine should not be switched off
in the meantime. If the periods for cooling down
during use of the machine are not sufficiently long,
the overheating protection will automatically stop the
welding process and the yellow LED in the front
panel will come on. The yellow LED switches off
when the machine has cooled down sufficiently and
is ready for welding.
Connection of electrode holder for MMA
The electrode holder and return current cable are
connected to plus tap (4) and minus tap (3). Observe
the instructions from the electrode supplier when
selecting polarity.

TECHNICAL DATA

Power source:
Mains voltage (50Hz-60Hz)
Fuse
Power, max.
Efficiency
Current range
Permitted load:
100% (40° ambient temp.)
60% (40° ambient temp.)
40% (40° ambient temp.)
15% (40° ambient temp.)
100% (20° ambient temp.)
60% (20° ambient temp.)
Open circuit voltage
Electrode diameter
Slope down
Gas post-flow
TIG-ignition
1
Application class
2
Protection class
Standards
Dimensions (LxWxH)
Weight
Static characteristic
U [V]
2
100
90
80
70
60
50
40
30
20
10
0
0 40
S
1
The machine meets the standards which are demanded of
machines working in areas where there is an increased risk of
electric shock
2
This machine is designed for indoor operation and meets the
requirements of protection class IP21.
11
TIG SCOUT 160 HP
1x230 V ±15%
16 A (20 A)
8.0 kVA
0.85
10-160 A
MMA
95 A
105 A
160 A
105 A
115 A
65 V
1.6 - 3.25 mm
0-10 s
0-30 s
HF / Liftig
S
IP 21
EN/IEC60974-1
EN/IEC60974-3
EN/IEC60974-10 (Class A)
42x20,5x34 cm
12 kg
Static characteristic
Tig Scout 160 HP, MMA
Tig Scout 160 HP, TIG
Norm line, MMA
Norm line, TIG
I [A]
2
80 120 160
TIG
105 A
125 A
160 A
115 A
135 A