Initial Operation / Technical Data - Migatronic RALLY MIG 160 Manuel D'instruction

Mounting of the machine
The machine should be mounted with turning wheels
and rear axle with rear wheels. The turning wheels can
be mounted without opening the machine. Use either a
ring spanner or a small wheel spanner.
Mains supply
The machine is designed for 230V (220-240V) and
must not be connected to other voltages.
Gas connection
The mashine is designed for use of a 6/10 kg gas
bottle with a maximum height of 100 cm. Larger
bottles must not be used due to risk of overloading the
machine or the machine will overturn.
Configuration
MIGATRONIC disclaims all responsibility for damaged
cables and other damages related to welding with
under sized welding torch and welding cables
measured by welding specifications e.g. in relation to
permissible load.
Warning
Connection to generators can damage the welding
machine.
When connected to a welding machine, generators
can produce large voltage pulses, which can damage
the welding machine. Use only frequency and voltage
stable generators of the asynchronous type.
Defects on the welding machine arisen due to
connection of a generator are not included in the
guarantee.
Dispose of the product according to local
standards and regulations.
www.migatronic.com/goto/weee
INITIAL OPERATING
TECHNICAL DATA
Mains voltage
Consumption (duty cycle 60%)
Fuse
Maximum input current
Open circuit voltage (DC)
Welding current range
Duty cycle, 20 %
Duty cycle, 60 %
Duty cycle, 100 %
Voltage adjustment
Insulation class
1
Protection class
Standards
Dimensions (LxWxH)
Weight
1
This machine is designed for indoor operation and meets
the requirements of protection class IP21.
8
Rally MIG 160
230 V / 50 Hz
4.8 kVA
T 13 A
21 A
17.5 – 31.5 V
30 – 150 A
150 A
90 A
70 A
5
F
IP 21
EN/IEC60974-1
EN/IEC60974-5
EN/IEC60974-1 (Class A)
715x370x650 mm
49 kg