Troubleshooting Guide - Grillo FD 2200 stage 5 Manuel D'utilisation

LUBRICATION POINTS WITH GREASE
Find the lubrication points following the scheme below. Grease the rear axle pivots, the pedals, the PTO
transmission belt guide pulley, the pivot connected to 2 points joint of the cutting deck, the grass catcher lifter
arms, the turbine shaft and its bearing every 50 hours (fig. no. 24).
PROBLEM
With the key in the «AVV.»
[ON] position the instrument
panel remains off
The instrument panel comes
on, but with the key in the
«ON» pos., the starter motor
does not turn
The starter motor turns but the
engine will not start
Loss in engine performance
while cutting
Engine stops when blades are
engaged
FD2200 stage 5/ Translation of the original instructions
TROUBLE-SHOOTING GUIDE
CAUSE
The battery is not providing any
current
The battery is not providing
enough current
No consent is given to start
No diesel flow
Plugs not warmed up enough
with cold engine
The timer does not give the
consent
The electro-stop does not run
its full travel
Forward speed too high for the
grass height
No consent is given for blade
engagement
16
REMEDY
- Check the connecting cables
- Check the electrolyte level
- Recharge the battery
- Replace the main fuse
- Recharge the battery
- Feed pedals in the «STOP» position
- Disengage the blades
- Sit on the driving seat
- Disengage the PTO
- Check fuel level in the tank
- Check the diesel filter (and replace if
necessary)
- Check that the breather hole in the fuel
cap is not blocked
- Wait for the plug light to go out
- Check the connections
- Replace the timer
- Check the travel of the electro-stop
- Replace the electro-stop
- Reduce speed
- Lift the cutting deck by a few notches
- Check the blades push button
- Operator sitting on driving seat
- Close the grass catcher
- Check the PTO engagement
electrovalve