Electrical System - Grillo FD 2200 stage 5 Manuel D'utilisation

Uneven cutting and
insufficient collection
Vibrations while working
Engine oil light comes on
CAUTION: If the problems continue after having carried out the operations described in this
manual, contact an Authorized Service Centre. Never attempt to make difficult reparations without
the necessary means and technical knowledge.
IMPACT WITH A STONE OR SOME OTHER FOREIGN OBJECT
1) Stop the machine.
2) Disengage the PTO.
3) Lift the cutting deck up.
4) Turn off the engine.
5) Pull the parking brake.
6) Check the blade fixing screws and the deck state.
7) Please check that the foreign body has not got into the turbine or the pipe.
MECHANICAL PARKING BRAKE
Always use the parking brake even if when the engine is off the machine brakes automatically. The brake
applies by pulling the handle upwards; to release it push the button and lower the handle. The engine keeps
on even when the operator leaves the driving seat, provided the parking brake is applied and the blades and
the turbine are disengaged. Make sure the parking brake cable (fig. 27, ref. A) is steadily adjusted.
PARKING BRAKE ADJUSTMENT AND EMERGENCY BRAKE PEDAL
The brake pedal has to make a 5 mm travel (fig. 27, ref. B).
IF THE MACHINE DOES NOT KEEP THE STOP
If the machine does not stop or drives backwards although the pedals are in the stop position, act on the
pump (fig. 28). This operation has to be carried out by an Authorised Service Centre.

ELECTRICAL SYSTEM

The electrical system is protected by fuses which, if blown out, cause the whole electrical system to cut out.
These are located:
1) On the left side, over the battery there is the general fuse with 70 A/h (fig. 29).
2) The operation fuse boxes are located under the seat and easily accessible via the maintenance door (fig.
30).
Once the fault has been located and repaired, replace the blown fuse with one of the same rating. Never
replace a fuse with another of a different rating. All relays are inside the box (fig. 31). A safety micro
switch controls that the grass catcher is in working position (fig. 32, ref. C), otherwise the turbine and the
cutting deck will not engage. If the electrical problems still persist even after having carried out the described
interventions, contact the Authorised Service Centre. Never attempt to carry out complex repairs without
having the necessary means and technical knowledge available.
FD2200 stage 5/ Translation of the original instructions
Cutting deck not parallel with
the ground
Blades not cutting correctly
Forward speed too high for the
grass height and the lawn
conditions
Grass duct blocked
Blades not balanced
Loose screws
Insufficient pressure
17
- Check tyre pressures
- Restore deck parallelism
- Check blades are fitted properly
- Sharpen or replace blades
- Adjust PTO belts tension
- Reduce forward speed
- Remove the deck and empty the grass
duct
- Check the engine revolutions, max.
2600 r.p.m.
- Clean the grass catcher grid
- Balance blades or replace them if
damaged
- Check and tighten the screws
fastening the blades, the engine and
the chassis
- Check engine oil level and top up if
necessary
- Change engine oil filter