Swing Function - mundoclima MUCR-H11 Série Manuel D'installation Et L'utilisauter

Lift panel function (only for some cassette specific panel)
1.When the unit is off，Press the Mode button long to
activate the lift panel function.The
Mode
The F2 mark appears when
the panel is adjusted.
2. Press the button + and - to control the lift and drop of the panel.
Pressing the + button can stop the panel,while it is dropping.
Pressing the - button can stop the panel,while it is lifting.

Swing function

(For the unit with left & right auto swing function only)
1 Up-Down swing
Swing
Press the Swing button to start up-down swing function.
Press it again to stop.
When the Up-Down swing function is activated,the
2 Left-Right swing
Swing
Press the Swing button long to start Left-Right swing function.
Press it again to stop.
When the Left-Right swing function is activated, the
Swing function
(For the unit without left & right auto swing function models)
Up-Down airflow direction and swing
Swing
Use SWING to adjust the up and down airflow direction.
1.Every time the user presses SWING, the louver swings six degrees.
2.Press and hold SWING for 2 seconds, it changes to the
UP−DOWN SWING mode. Press SWING again to stop.
When the Up-Down swing function is activated,the
(Not applicable to all the models)
The operation can refer to the following instructions for the unit with
four Up-Down louvers can be operated individually.
1.Press the Swing button to activate the Up-Down
adjusting louver function.
The mark will flash.(Not applicable to all the models)
2.Pressing the button "+" or"-" can select the movement
of four louvers.Each time you push the button,the wire
controller select in a sequence that goes from:(the icon
means the four louvers move at the same time.)
-0
-0 -1 -2
3. And then use Swing button to adjust the Up-Down airflow direction
of the selected louver.
-3
-4
99
mark will flash.
mark appears.
mark appears.
mark appears.
Swing
-
+