Installation Accessory; Installation Method - mundoclima MUCR-H11 Série Manuel D'installation Et L'utilisauter

2. Installation accessory

2.1 Select the installation location
Don't install at the place where cover with heavy oil, vapor or sulfureted gas,
otherwise, this product would be deformed that would lead to system malfunction.
2.2 Preparation before installation
1. Please confirm that all the following parts you have been supply.
No. Name
1
Wire controller
2
Installation and owner's manual
3
Screws
4 Wall plugs
5
Screws
6 Plastic screw bars
7
Battery
8
Connection cables (CL97448 + CL97079)
2. Please filed install the following accessory.
No.
Name
1
Switch box
Wiring Tube(Insulating
2
Sleeve and Tightening
Screw)
Precaution of install the wire controller
1. This manual provides the installation method of wire controller. Please refer to the
wiring diagram of this installation manual to wire the wire controller with indoor unit.
2. The wire controller working in low voltage loop circuit. Forbid to directly contact the
cable of 220V commercial electricity or of 380V high voltage, and don't wire this kind
of wire in the said loop; wiring clearance between configured tubes should at the
range of 30~50 cm or above.
3. The Shielded wire of the wire controller must be grounded reliable.
4. Upon finish the wire controller connection, do not employed tramegger to detect the
insulation.

3. Installation method

1. Dimensions
120mm
123mm
Qty. Remarks
1
1
3 M4X20 (For Mounting on the Wall)
For Mounting on the Wall
3
2
M4X25 (For Mounting on switch box)
For fixing on switch box
2
1
1 For connection to the IDU main PCB
Specification
Qty.(embeded
(only for reference)
into wall)
1
1
18.5mm
46mm
62mm
Fig 3-1
92
Remarks
83.5mm