mundoclima MUCR-H11 Série Manuel D'installation Et L'utilisauter page 98

Fan speed setting
Press the FAN SPEED button to set the fan speed.
(This button is unavailable when in the mode of Auto or Dry)
Fan speed
(Lock)
Room temperature sensor selection
Copy/
Follow me
Press the Follow me button to select whether
the room temperature is detected at the indoor
unit or the wire controller.
When the Follow me function indication
room temperature is detected at the wire controller.
Child lock function
Press the Lock botton for 3 seconds to activate the child lock
function and lock all buttons on the wire controller.
Press the button again for 3 seconds to deactivate the child
lock function.
Fan speed
(Lock)
When the child lock function is activated,the
Keypad tone setting
Swing Timer
°C & °F scale selection (on some models)
Copy/
Back/Turbo
Follow me
℃ ℉
Turbo/Auxiliary Heat function (on some models)
•
Press TURBO to activate/deactivate the Turbo/Auxiliary
Back/Turbo Heat function. The turbo function sets the unit to reach
the user's present temperature in the shortest amount of
time possible.
•
When the user presses TURBO in the COOL mode, the
unit sets to the highest fan speed setting to jump−start
the cooling process.
•
When the user presses TURBO in the HEAT mode, for
units with AUX. HEAT, the AUX. HEAT activates and
jump−starts the heating process.
appears,the
mark appears.
Press the buttons Swing and Timer simultaneously for
3 seconds to close the keypad tone.
Press the buttons again for 3 seconds to open the keypad
tone.
Press the buttons Back and Copy simultaneously
for 3 seconds will alternate the temperature display
between the ℃&℉ scale.
98
Indoor Unit