mundoclima MUCR-H11 Série Manuel D'installation Et L'utilisauter page 94

5. Wire the indoor unit
There are three methods:
1 from the rear;
2 from the bottom;
3 from the top;
1
PCB
1
4. Notch the part for the wiring to pass through with a nipper tool.
NOTE: DO NOT allow water to enter the remote control.
Use the trap and putty to seal the wires.
Putty
6. Reattach the upper part of the wire controller
After adjusting the upper case and then buckle the upper case; avoid clamping the
wiring during installation. ( Fig 3-7 )
Fig 3-7
2
PCB
Connection cable (4 wires - 6 m)
4-core shielding wire
(supplied with the accesories (CL97448)
Trap
Putty
Trap
Fig 3-6
All the pictures in this manual are for
explanation purpose only.
Your wire controller may be slightly
different .The actual shape shall prevail.
94
3
PCB
Main board
CN40
Connection cable (4 wires)
(supplied with the accesories (CL97079)
Putty
Trap
1