Fault Alarm Handing; Technical Indication And Requirement - mundoclima MUCR-H11 Série Manuel D'installation Et L'utilisauter

Delete the time scale in one day.
1
Confirm
2
Confirm
- +
3
Day off/Del
- +
Press + and − to select the setting time want to delete. The setting time,
mode, temperature and fan speed appear on the LCD. The setting time,
mode, temperature and fan speed can be deleted by pressing the DEL
(day off ).

11. Fault alarm handing

If the system does not properly operate except the above mentioned cases or the
above mentioned malfunctions is evident, investigate the system according to the
Wired controller error codes
Nº Code
1 F0 Error of communication between wire controller and indoor unit
2 F1 The lifting filter function is abnormal
3 F2 The air inlet grill doesn't fit well of Super slim four-way cassette
4 E0 Error of power supply phase sequence
5 E1 Error of communication between indoor unit and outdoor unit
6 E2 T1 temp. sensor is abnormal
7 E3 T2A temp. sensor is abnormal
8 E4 T2B temp. sensor is abnormal
9 E5 T3/T4 temp. sensor is abnormal or compressor discharge temp. sensor is abnormal
10 E6 Zero crossing detection error
11 E7 EEPROM malfunction
12 E8 Fan speed out of control
13 E9 The communication between main board and the display board is abnormal
14 EA Compressor over current protection (four times)
15 EB IPM malfunction
16 ED Outdoor unit malfunction
17 EE Water-level alarm and other malfunction
18 EF Other malfunction
Please check the error display of indoor unit and read <<OWNER'S MANUAL>>
if other error code appears.

12. Technical indication and requirement

EMC and EMI comply with the CE certification requirements.
Note:
The design and specifications are subject to change without prior notice for product
improvement. Consult with the sales agency or manufacturer for details
During the weekly timer setting,
press CONFIRM.
Press + and − to select the day of the week
and then press CONFIRM.
ex. Delet the time scale 1 in saturday
Description
104