Installing The Inlet Pipe; Installing The Inlet Hose - Heidolph Laborota 4000 efficient Mode D'emploi

Setup and initial use
4.5.9
4.5.10
96

Installing the inlet pipe

The inlet pipe consists of:
cock plug
PTFE hose
drain disk
Fig. 4-12: Installing the inlet pipe
1. Shorten the PTFE hose (1) to the desired length.
2. Grease the cock plug.
3. Position the drain disk (2) so that the condensed liquid can not flow back
into the evaporating flask via the PTFE hose (1).
4. Insert the inlet pipe.

Installing the inlet hose

Fig. 4-13: Installing the inlet hose
1. Guide the inlet hose (4) through the cap (3) and seal (2) at the inlet tap (1).
2. Turn the cap (3) to the right.
The inlet hose (4) is not installed on the inlet tap (1).
Laborota 4000/4001 efficient, 4010/4011 digital, 4002/4003 control
1.02