Cleanmaxx PC-P008E Mode D'emploi page 24

EN
Emptying the Dust Container and Cleaning the Foam Filter
closed
open
e
Cleaning the HEPA fi lter and the fi lter holder
1. Empty the dust container (7) (see above). Do not close the bottom fl ap (e).
2. Reach into the dust container. Turn the fi lter holder (g) a little until it is released and
can be removed.
f
7. Let all parts dry completely in the air before you reassemble them. NOTICE: Never
assemble wet or damp components or attach them to the motor unit (3)! The
device is assembled in the reverse order.
Cleaning the Main unit, Extension Tube and Nozzles
• Wipe down the main unit (3), extension tube and nozzles with a damp, soft cloth if
necessary. Then dry them with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
Cleaning the Electrical Floor Nozzle
To make it easier to clean, the brush can be removed from the electrical fl oor nozzle (9):
1. Remove the dust container (7) from the motor unit (3).
Turn it a little to do this. It is released from the motor unit
and can be removed.
2. Remove the foam fi lter from the top of the dust container,
tap it out and clean it with a soft brush if necessary.
3. Hold the dust container over an open dust container. The
distance from the dust container should be as small as
possible so that the dust does not spread in the surroun-
ding air.
4. Pull the catch of the bottom fl ap (e) away from the dust
container slightly. The bottom fl ap will open and the dirt
will fall out.
5. To close it, press the bottom fl ap onto the dust container.
The catch must be heard to engage in place.
3. Pull the HEPA fi lter (f) out of the fi lter holder.
4. Tap out both parts and clean them with a soft brush if
necessary.
g
5. The fi lter holder can also be rinsed with clear water.
NOTICE: Do not wet-clean the HEPA fi lter!
6. Wipe out the dust container with a damp cloth if necessary.
1. Slide the latch fastener on the bottom of the electrical
fl oor nozzle towards the small wheel on the electrical
fl oor nozzle.
24