Pan Detection; Cooking-Timer/Alarm; Indications In The Display - ETNA AKI586ZT Mode D'emploi

USE
Boost power management Due to the restricted power of the induction hob, the boost
function can only be set on one cooking zone simultaneously (for both left or right cooking
zones). Both cooking zones can be set to level 9. If one cooking zone is on the Boost level, the
other cooking zone can be set maximal to level 7/8.
The cooking zone, which is set to a lower power, will be flashing in the display.
▷

Pan detection

If the induction hob does not detect a (ferrous) pan after the cooking level has been set, the pan
detection symbol flash in the display. Set a suitable pot or pan on the cooking zone. If, after 10
minutes no pot or pan is detected the cooking zone will switch off.

Cooking-timer/alarm

• A cooking-timer can be set for each cooking zone.
• The hob also has an alarm. Both the cooking-timer as well as the alarm can be set for a
maximum of 99 minutes.
• The alarm works in the same way as the cooking-timer, but is not linked to a cooking zone.
If the alarm has been set, it will continue counting down after the cooking zone has been
switched off.
• The alarm can only be switched off when the hob is switched on.
Select the desired function:
1. Cooking-timer — the timer is linked to a cooking zone. After the set time has elapsed, the
cooking zone will switch off automatically.
2. Alarm — the alarm only beeps after the set time has elapsed.

Indications in the display

Cooking
zone
display
<->
EN 10
Cooking zone status
Power level cooking zone; 1 = low level / 9 = high level
Cooking zone boost level active.
No (suitable) pan on cooking zone (pan detection symbol).
Fault code; See 'Troubleshooting table'.
Residual heat indicator; The hob has a residual heat indicator for each cooking
zone to show those which are still hot. Although the hob is switched off, the
indicator 'H' will remain on for as long as the cooking zone is hot!
Avoid touching them when this indicator is lit. Danger! Risk of burns.