ETNA AKI586ZT Mode D'emploi page 101

MAINTANANCE
Symptom
n
appears in the display.
Some touch controls are not
working.
Flash symbol in the display.
Error code U400 and/or
continuous beep.
Code G on downdraft display
(alternately with the selected
power.)
Code S on downdraft display
(alternately with the selected
power.)
Flashing 8 on downdraft
display.
Other error codes.
Possible cause
The bridge function
is activated.
You have pressed two or more
keys at the same time.
The control panel is dirty or has
water lying on it.
The appliance has been
connected incorrectly and/or
the mains voltage is too high.
Grease filter 30
operating hours.
Carbon filter 120
operating hours.
Excess liquids inside the
downdraft interior.
Defective generator.
Solution
Deactivate the bridge
function.
Do not operate more than one
key at the same time.
Clean the control panel.
Let your connection be
changed.
Clean the grease filter.
Use the downdraft clean
function.
Replace the carbon filter.
Use the downdraft clean
function.
Dry and clean the downdraft
interior (see: Presence of liquids
inside the device).
Contact the service
department.
EN 23