Maintenance; Cleaning; Filters And Collect Tray - ETNA AKI586ZT Mode D'emploi

MAINTENANCE

Cleaning

First use
Use a damp cloth to clean and dry the glass surface before using it for the first time.
It is recommended to dry the appliance after having cleaned it with a damp cloth, in order to
prevent the build-up of limescale.
Daily cleaning
• Although food spills cannot burn into the glass, we nevertheless recommend you to clean the
hob immediately after use.
• Best for daily cleaning is a damp cloth with a mild cleaning agent.
• Dry with kitchen paper or a dry teacloth.
Stubborn stains
• Stubborn stains can also be removed with a mild cleaning agent such as washing-up liquid.
• Remove watermarks and lime scale with vinegar.
• Metalmarks (caused by sliding pans) can be difficult to remove. Special agents are available.
• Use a glass scraper to remove food spills. Melted plastic and sugar is also best removed with a
glass scraper.
Never use abrasives. They leave scratches in which dirt and lime scale
can accumulate. Never use anything sharp such as steel wool or scourers.

Filters and collect tray

Grease filter indicator
In the display the grease filter indicator G will light up after 30 (downdraft) operating hours. During
use, the indicator flashes alternating with the chosen suction mode.
1. Touch either the plus (+) or minus (-) key to stop the flashing.
The suction mode is displayed. When the downdraft is switched off, the grease filter
▷
indicator G is shown in the display again.
2. The grease filters should then be cleaned.
3. Reset the memory by touch and hold the worktop extractor plus (+) key 5 seconds until the
grease filter indicator G disappears from the display.
EN 20