Pan Detection; Boost; Indications In The Display - ETNA KIS560ZT Mode D'emploi

USE

Pan detection

• If the hob does not detect a (ferrous) pan after the cooking power has been set, the pan
detection symbol and the selected power setting will flash alternately in the display and the
hob will remain cold.
• If a (ferrous) pan is not placed on the cooking zone within 2 minute, the cooking zone will
automatically switch off (see also chapter 'Pans').

Boost

• The 'Boost' function is used to cook at maximum power for a short period of time
(maximum 5 minutes). The power is reduced to the previous setting at the end of the
maximum boost time. Boost can only be set if the temperature of the hob allows it.
• When 'Boost' is active no cooking timer can be set.

Indications in the display

In display Status
Power setting cooking zone; 1 = low setting / 9 = high setting
Boost function active
Timer link indication
Child protection lock function selected
Warming function selected
No (suitable) pan on cooking zone (pan detection symbol)
Pause function active
Fault code; See 'Troubleshooting table'
EN 10
Residual heat indicator; The hob has a residual heat indicator for each cook-
ing zone to show those which are still hot. Although the hob is switched off,
the indicator 'H' will remain on for as long as the cooking zone is hot! Avoid
touching them when this indicator is lit. Danger! Risk of burns.