Technical Specifications - ETNA AKI586ZT Mode D'emploi

TECHNICAL SPECIFICATIONS

Table of appliance errors.
These errors appear on the cooking top display.
Error code
C, E, C flashing, E
flashing or
- symbol
E2
E3
E4, E5, E6, E7, E8, E9,
EA, EC, EH,
No display / Function
u
Er31, Er47, Er22, Er20
or segments on the
display lighting up
cyclically
EN 24
Description
If the display in
one of the cooking
zones shows one
of these symbols,
an intervention
has occurred or
is occurring in the
system's basic
configurations.
Excessive
temperature on the
cooking zone.
Malfunction due to the
use of inappropriate
cookware materials.
Hardware fault
Voltage or touch
control error.
Pot not detected
Touch control fault
Possible causes
Problems or changes
detected to the
system's basic
configurations.
Overheated pot.
Pots of
inappropriate
material or
possible loss of
magnetic properties at
higher temperature.
Hardware errors
detected
Faulty electrical
connection or faulty
component.
Inappropriate
cooking pot
Touch control error
detected
Solution
Contact the
authorised service
centre, specifying the
error code.
Allow the system
to cool down,
decreasing the power
or removing the pot.*
Use pots of a suitable
material or replace
them.*
Contact the
authorised service
centre, specifying the
error code.
Contact the
authorised service
centre, specifying the
error code.
Use a suitable pot.
Refer to the section of
the manual on suitable
recipients.*
Contact the
authorised service
centre, specifying the
error code.