ETNA AKI586ZT Mode D'emploi page 97

OPERATION
Motor on/off key (15):
When touched, this key starts the motor if touched again, it stops the motor.
By operating the keys "+" and "-" the user can modify the suction speed (power). For the version
with 4-speed (serial) motor, only the 4th speed is timed.
Suction speed (power) decrease key (2):
When touched, the key "-" decreases the suction speed of the downdraft.
Suction speed (power) increase key (3):
When touched, the key "+" increases the suction speed of the downdraft.
Filter reset key (16):
When touched, this key will reset the warnings on anti-grease metal filter.
After 30 hours of hood operation, the key symbol (14) alternating with the key symbol (16), will
flash indicating the need to clean the anti-grease metal filters.
This alarm prevents the operation of the suction system until it is reset, to allow the condensate
tray to empty (operation to be performed as needed, but however each time you reset the filters).
Filter reset key (Active only in filtration mode) (14):
After 120 hours of operation of the hood, the keysymbol (14), alternating with the symbol (2), will
flash indicating the need to clean/replace the activated carbon filters.
The carbon filters can be washed in the dishwasher once, and then they must be replaced.
NOTE: In extraction mode, the alarm of carbon filters is disabled.
Timer key (1):
When touching key (1), the timer will be enabled, regardless of the selected suction speed.
•
Upon first touch, the time will be 5 minutes (shown by a flashing button on the key),
• The second touch corresponds to 10 minutes (double flashing time).
• The third touch corresponds to 20 minutes (triple flashing time).
• The timer key will flash throughout the entire operation.
Touching the key a fourth time will disable the timer function.
Intensive key (4):
When touching key (4), the motor switches directly to the intensive phase, the key activates and
deactivates the intensive speed (4th speed, timed for approx. 8 minutes).
The timing of speed is active only in extraction mode
EN 19