Pan Detection; Indications In The Display - ETNA KI160ZT Mode D'emploi

USE

Pan detection

If the hob does not detect a (ferrous) pan after the cooking power has been set, the pan
detection symbol and the selected power setting will flash alternately in the display and the hob
will remain cold. If a (ferrous) pan is not placed on the cooking zone within 1 minute, the cooking
zone will automatically switch off (see also chapter 'Pans').

Indications in the display

In
Status
display
Power setting cooking zone; 1 = low setting / 9 = high setting
Boost function active
No (suitable) pan on cooking zone (pan detection symbol)
Child lock function selected
Bridge function selected
Cooking function selected
Baking function selected
Keep warm function selected
Chocolate melt function selected
Residual heat indicator; The hob has a residual heat indicator for each cooking
zone to show those which are still hot. Although the hob is switched off, the
indicator 'H' will remain on for as long as the cooking zone is hot!
Avoid touching them when this indicator is lit. Danger! Risk of burns.
Pause function selected
Fault code; See 'Troubleshooting table'
EN 10