Resetting The Appliance; Lengthy Downtimes Of Appliance - Angelo Po 1G1FA0E Manuel D'utilisation Et D'installation

2 - Turn the knob (B) to setting 1, between the mi-
nimum and maximum temperature, and wait for
the warm-up time before using the oven.The li-
ghts (C) and (D) is on, the light (C) goes out
once the temperature is reached.
3 - Turn the knob (B) to setting 2 to turn on the top
heating element.

RESETTING THE APPLIANCE

If the safety thermostat is
tripped, the appliance has to
be restored to the initial
working conditions as fol-
lows.
1 - Pull off the knob (A).
2 - Undo the screws (C)
and remove the control
panel (B).
3 - Press the button (D) of
the safety thermostat to
restore the electricity
supply.
4 - Replace the control panel (B) and the knobs (A)
on completion of the operation.

LENGTHY DOWNTIMES OF APPLIANCE

If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Turn off the gas supply tap.
2 - Cut off the mains electricity supply using the ap-
pliance's master switch.
3 - Clean the appliance and the surrounding areas
thoroughly.
Turning off
4 - Turn the knob (B) to setting 3, to switch off the
heating elements.
The mains (D) and temperature (C) lights go
out.
5 - Turn off the appliance's circuit breaker to disconnect it
from the electrical mains.
A
4 - Spread a film of edible oil over the stainless
steel surfaces.
5 - Carry out all the servicing procedures.
6 - Leave the appliance uncovered and the cook-
ing chambers open.
- 11 -
C
B
D
IT
GB
DE
IDM-39616600800.tif
FR
ES
English