General Information; Storage - Agilent Technologies Turbo-V 2300 Rack Controller Notice De Mode D'emploi

16 Instructions for Use

General Information

General Information

This equipment is intended for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not be
held responsible for any events occurring due to non-compliance, even
partial, with these instructions, improper use by untrained people, non-
authorized interference with the equipment or any action contrary to
that provided for by specific national standards. The Turbo-V 2300 Rack
Controller are microprocessor-controlled, solid-state, frequency
converters with self-diagnostic and self-protection features.
This manual uses the following conventions:
The caution messages are displayed before procedures which, if not followed,
CAUTION!
could cause damage to the equipment.
WARNING! The warning messages are for attracting the attention of the operator to a
particular procedure or practice which, if not followed correctly, could lead to
serious injury.
The notes contain important information taken from the text.
NOTE

Storage

When transporting and storing the controllers, the following
environmental requirements should be satisfied:


194/262
temperature: from -20 °C to + 70 °C
relative humidity: 0 – 95 % (without condensation)
Turbo-V 2300 Rack Controller User Manual / 87-901-022-01 (B)