Agilent Technologies Turbo-V 2300 Rack Controller Notice De Mode D'emploi page 248

17 Technical Information
Use
Figure 32
The run up time is factory-set to: 00h 08m 00s.
When the last digit is entered, the display shows:
D
Where: XXX = YES or NO.
This function is factory-set to YES.
248/262
Press the PUMP CURRENT push-button to enter the data.
Press the PUMP CURRENT push-button to enter the data.
E L A Y
T H R E S
Press the CYCLE NUMBER push-button and select YES if relay R2
must operate only after the run-up time or select NO when the R2
operation is needed right from start of the turbopump and after
the rotational speed of the turbopump exceeds for the first time
the speed threshold value (see the preceding cycle diagram).
Turbo-V 2300 Rack Controller User Manual / 87-901-022-01 (B)
Turbo V 2300
Turbo-V 3K-T
E V E N
H O L D :
A F T E R
X X X