General Information - Agilent Technologies Turbo-V 1001 Rack Mode D'emploi

16 Instructions for Use

General Information

General Information

This equipment is intended for use by professionals. The user should
read this instruction manual and any other additional information
supplied by Agilent before operating the equipment. Agilent will not
be held responsible for any events occurring due to non-compliance,
even partial, with these instructions, improper use by untrained
people, non-authorized interference with the equipment or any
action contrary to that provided for by specific national standards.
The Turbo-V 1001 Rack Controller are microprocessor-controlled,
solid-state, frequency converters with self-diagnostic and self-
protection features.
Controller features:





The following paragraphs contain all the information necessary to
guarantee the safety of the operator when using the equipment.
Detailed information is supplied in the appendix "Technical
Information".
196/288
Input voltage auto setting
Front / Remote / Serial Operation
24 Vdc pump fan cooling drive
Vent & Purge valves drive
Pump speed reading after stop command (stop speed reading)
Turbo-V 1001 Rack Controller User Manual / 87-901-033-01