General Information - Agilent Technologies TwisTorr Medium-TMP Mode D'emploi

17 Instructions for Use

General Information

General Information

This equipment is destined for professional use. Before operating the
equipment, the user should read this instruction manual and any
other additional information supplied by Agilent. Agilent declines
any responsibility for non-compliance, even partial, with these
instructions, improper use by untrained persons, unauthorized
repairs of the equipment or use not complying with specific national
standards. The TwisTorr Medium-TMP onboard Controller is suitable
for use with TwisTorr 404/704/804 FS pumps. It is equipped with
auxiliary connectors that make it possible to power an additional
fan, to control the vent valve and for remote operation of the
TwisTorr Medium-TMP onboard Controller by a host computer
connected on a serial line (RS232 or RS485). The following
paragraphs contain all the information necessary to guarantee
operator safety when using the equipment. For detailed information,
refer to the "Technical Information" appendix.
The following conventions are adopted in this manual:
Caution messages are displayed before procedures which, if not followed, may
CAUTION!
cause damage to the equipment.
WARNING!
Warning messages are intended to draw the operator's attention to a
particular procedure or practice which, if not followed correctly, may cause
serious injury.
TwisTorr Medium-TMP onboard Controller User Manual / 87-901-050-01 (B)
134/181