Agilent Technologies Turbo-V 2300 Rack Controller Notice De Mode D'emploi page 242

17 Technical Information
Use
R
S
Figure 24
This message will only be displayed if the RS 232 interface is present.
Where: SELECTION: XXXXX = means HOST or PRINT.
The controller is factory-set to HOST
With the RS 232/485 connected, a bi-directional communication is
established by selecting HOST. Data are sent to an external computer
every time the external computer asks for the values.
The available data are listed in the read mode in the serial protocol
table.
With the serial module installed, the data can also be read in the FRONT or
NOTE
REMOTE mode.
242/262
If the RS 232 is installed, enter the value by pressing the PUMP
CURRENT push-button and, if the serial option is installed, the
display shows:
S X X X
E L E C
Turbo-V 2300 Rack Controller User Manual / 87-901-022-01 (B)
H O S T
T I O N :
Turbo V 2300
Turbo-V 3K-T
/ P R I N
X X X
T
X X