Publicité
16
Instructions for Use
General Information
General Information
This equipment is destined for professional use. Before operating the
equipment, the user should read this instruction manual and any
other additional information supplied by Agilent. Agilent declines
any responsibility for non-compliance, even partial, with these
instructions, improper use by untrained persons, unauthorized
repairs of the equipment or use not complying with specific national
standards. The TwisTorr 74 FS AG On-board controller is suitable
for use with TwisTorr 74 FS pumps. It is equipped with auxiliary
connectors that make it possible to power an additional fan, to
control the vent valve and for remote operation of the On-board by a
host computer connected on a serial line (RS-232 or RS-485). The
following paragraphs contain all the information necessary to
guarantee operator safety when using the equipment. For detailed
information, refer to the "Technical Information" appendix.
The following conventions are adopted in this manual:
Caution messages are displayed before procedures which, if not followed, may
CAUTION!
cause damage to the equipment.
WARNING!
Warning messages are intended to draw the operator's attention to a
particular procedure or practice which, if not followed correctly, may cause
serious injury.
The notes contain important information taken from the text.
NOTE
134/192
TwisTorr 74 FS AG On-board Controller User Manual / 87-901-054-01
Publicité
Chapitres
