Deleting Data From Memory; Keeping Data In Memory - Hürner WeldControl 2.0 160 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
If the welding unit recognizes a problem that cannot be
cleared while the data transfer is in progress, it does not
resume the process and displays a "Download cancelled"
Info error message. To acknowledge this error, press the START/
SET key.
5.5

Deleting Data from Memory

The report data in memory can be deleted only after all welding reports
were transferred, which is indicated by the "Download completed"
message. When the storage media is unplugged, a "Delete Memory"
message appears. If the START/SET key is pressed at this point, a fur-
ther confirmation message "Delete Memory, sure?" is shown, which
has to be confirmed by pressing the START/SET key once again. Then,
the report data in memory are deleted.
5.6

Keeping Data in Memory

When the cable or storage media is unplugged, a "Delete Memory"
message is displayed. Press the STOP/RESET key to keep the current
report data in memory. They can then be printed off once again.
Make a habit of handling the internal storage as described
at the beginning of Sect. 5, to maintain data integrity and
avoid any inadvertent deletion of the reports in memory.
Important
6 Service and Repair
As the product is used in applications sensitive to safety considerations,
it may be serviced and repaired only on our premises or by partners
who were specifically trained and authorized by us. Thus, constantly
high standards of operation quality and safety are maintained.
Non-compliance with this provision will dispense the manu-
facturer from any warranty and liability claims for the product
and any consequential damage.
Important
7 Service and Repair Contact
HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specifications of
the product without prior notice.
Info
8 Accessories/Parts for the Product
Facing Tool Blade for HÜRNER WeldControl 2.0 160
Only genuine spare parts are acceptable. The use of non-
genuine parts voids any and all liability and warranty on the
part of the manufacturer.
Info
Version January 2018
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER WeldControl 2.0 160 User's Manual
25
EN