Adjustment Of The Drawer Height; Accessories On Request - Steel Cucine B9C-4 Manuel D'utilisation

UK
Installation

Adjustment of the drawer height

The clips of height adjustment are located in the lower
side and at the right and left ends of the drawer.
• By turning the lever "A" the drawer will raise of 3 mm.

Accessories on request

Utensil holder
The utensil holder is a steel frame for storing utensils and
tools inside the gas bottle compartment.
To fit the holder, proceed as follows:
• open the door of the gas bottle compartment;
• place the frame onto the 4 fastening pins "A" already
secured to the inside of the door;
• push the frame downwards until the pins fit into the slots
"B".
To remove the frame, lift upwards then away from the
pins.
Assembling the ceramic tiles kit
D
F
D
F
1. Remove the grill grates "A", griddles "B" and disperser "C" (one per kit to be installed).
2. Place the two side supports "D" and the central support "E" (for double kit only) in the combustion
chamber.
3. Position the crosspieces "F" in the slots made in supports "D" and "E".
4. Rest the tiles on the frame as shown in the figure.
5. Replace the grill grates "A" and griddles "B".
64
26
F
C
D
F
E
D
A
A
B
A
B
A
B