Connecting The Gas Bottle (Green) (Category Ii2H3+) - Steel Cucine B9C-4 Manuel D'utilisation

UK
Installation

Connecting the gas bottle (Green) (category II2H3+)

THE APPLIANCE IS ALREADY REGULATED TO OPERATE WITH LPG (G30/31 AT 28-30/37MBAR).
LPG
NEVER CONNECT THE PIPES DIRECTLY TO THE GAS BOTTLE: A PRESSURE REGULATOR MUST ALWAYS
BEEN INTERPOSED.
1) Remove the lower rear panel "F": pull it up and ahead.
2) Remove the upper rear panel "G": pull it up and ahead.
3) Provide a gas pipe of 800 mm length. You may need a pipe holder "H" on the end of the ramp "E".
4) Connect the end "A" of the gas pipe directly to the ramp "E" or to the pipe holder "H".
5) Connect the end "I" of the gas pipe to the pressure regulator "C".
6) Connect the gas pressure regulator "C" to the threaded union "B" on the bottle.
7) When the gas bottle is inside the chart make the gas tube going trough the hole "D" then connect.
8) Fit the rear panels "G" and "F" putting in position then pulling down.
AFTER CONNECTING, ENSURE THE RUBBER PIPE IS NOT CRUSHED, HANGING OR OBSTRUCTING THE
HOLE IN THE LID.
C
B
The symbols in the picture mean that on those points a clamp could be necessary.
50
12
A
I
H
E
G
F
D