Specifications - Stihl MS 170 Notice D'emploi

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
Engine
STIHL single cylinder two-stroke engine
MS 170
Displacement: 30.1 cm
Bore: 37 mm
Stroke: 28 mm
Engine power to 1.3 kW (1.8 bhp)
ISO 7293: at 8,500 rpm
Idle speed: 2,800 rpm
MS 180, MS 180 C
Displacement: 31.8 cc
Bore: 38 mm
Stroke: 28 mm
Engine power to 1.5 kW (2.0 bhp)
ISO 7293: at 9,000 rpm
Idle speed: 2,800 rpm
MS 170, MS 170 C, MS 180, MS 180 C
Ignition System
Electronic magneto ignition
Spark plug (resistor
type):
Electrode gap:
This spark ignition system meets all
requirements of the Canadian
Interference-Causing Equipment
Standard CAN ICES-2/NMB-2.
Fuel System
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity:
Chain Lubrication
Fully automatic, speed-controlled oil
pump with rotary piston
3
Oil tank capacity:
Weight
dry, without bar and chain
MS 170:
MS 180:
MS 180 C with quick chain
adjuster:
MS 180 C with quick chain
adjuster and
Easy2Start:
Cutting Attachments for MS 170
Actual cutting length may be less than
the specified length
Bosch WSR 6 F,
STIHL cutting attachments complying
NGK BPMR 7 A
with CSA Standard CAN 3-Z 62.3:
0.5 mm
Rollomatic guide bars
Cutting lengths:
Pitch:
Groove width:
1)
3/8" Picco chain
Picco Micro Mini 3 (61 PMM3)
250 cc (0.25 l)
Type 3610
Pitch:
Drive link gauge:
Chain sprocket
6-tooth for 3/8" P (spur sprocket)
145 cc (0.145 l)
Other cutting attachments
Other cutting attachments complying
with CSA Standard Z 62.3 are available:
see section CSA Standard Z 62.3, the
chain leaflet inside the chain box or
3.9 kg
contact your local STIHL dealer.
3.9 kg
Please ask your STIHL dealer to
properly match your powerhead with the
4.0 kg
appropriate bar/chain combinations to
reduce the risk of kickback injury.
4.2 kg
MS 180, MS 180 C
Actual cutting length may be less than
the specified length
1)
30, 35, 40 cm
3/8" P (9.32 mm)
1.1 mm
Actual cutting length may be less
than the specified length
3/8" P (9.32 mm)
1.1 mm
English
45