Tensioning The Saw Chain (Front Chain Tensioner) - Stihl MS 170 Notice D'emploi

English
Releasing the chain brake
Pull hand guard towards the front
N
handle until it engages audibly –
chain brake is released
Fitting the saw chain
WARNING
Put on protective gloves – risk of injury
by the sharp cutters
Fit the chain starting at the nose of
N
the guide bar
22
1
3
1
2 4
Position the guide bar over the
N
bolts (1) – the cutting edges of the
saw chain must point to the right
Position the locating hole (2) over
N
the peg of the tensioner slide –
simultaneously place the saw chain
over the sprocket wheel (3)
Turn screw (4) to the right until there
N
is very little chain sag on the
underside of the bar – and the drive
link tangs engage in the bar groove
Refit the chain sprocket cover – and
N
then screw on the nut by hand until
it is fingertight
Go to chapter "Tensioning the saw
N
chain"
Tensioning the Saw Chain
(front chain tensioner)
1
Retensioning during cutting work:
Switch off the engine.
N
Loosen the nuts.
N
Hold the bar nose up.
N
Use a screwdriver to turn the
N
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
While still holding the bar nose up,
N
tighten down the nuts firmly.
Go to "Checking Chain Tension".
N
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently –
N
see chapter on "Operating
Instructions".
MS 170, MS 170 C, MS 180, MS 180 C