Program Management - Alliance Bio Expertise MEDIAWEL 30 Manuel D'utilisation

Creation / modification of a user name
CYCLE
PARAMETERS
PROGRAMS
USERS
SETTINGS
MAINTENANCE
31.7°
24/03/2016
16:46:35
Following the creation or modification of a user name, a "Modifications saved" message appears for 2
seconds. You are then returned to the "Selection of a user name to be created / deleted / modified" screen

Program management


Cycles: general principles
The automated preparator enables a "preparation cycle" to be automatically performed for a volume of
culture medium.
The volume written is automatically the last one recorded. Up to the user to modify the volume to be
prepared.
A preparation cycle comprises n "steps"; n = 2, 3 or 4
Each step is defined by a temperature setpoint (in °C) and a duration (in minutes)
The temperature setpoint for a step is equal to or greater than 25.0°C and equal to or lower than 125.0°C.
It is defined to the nearest 0.1°C
The duration of a step is equal to or greater than 1 minute and equal to or less than 999 minutes. It is
defined to the nearest 1 minute.
The duration of the last step is always infinite (the preparation cycle is stopped by the user).
The start of the preparation cycle is triggered either by the user (manual start), or by means of a timer
(scheduled start).
The phases between the steps are transition phases, which may be "heating" or "cooling".
Overshoot can happen during the distribution step . It is strongly recommended to wait for the stabilization .
User's name N° 02
1 2 3 4
A Z E R
Q S D F
W X C V
86
5 6 7 8
T Y U I
G H J K
B N .

9 0
O P 
L M
✓
- /