Cleaning
Sequence
of
operations
1
-
2
-
3
-
4
-
5
-
-
6
-
-
-
-
7
-
-
8
-
9
-
10
-
11
-
-
Remove the dispensing hose and immediately rinse it with very hot
water
Open the lid
Open the hatch and place a bucket beneath the vessel or position
the device over a floor drain
Switch the device off
Disable the system's circuit breaker,
Unplug the power cable,
Remove the decanting tubing "B"
Remove the stirrer "C"
Remove the plug "D"
Take these three components and place them in a deep sink for
immediate rinsing in very hot water
Wash the vessel in very hot water using a soft brush
Wash the decanting and adding caps in very hot water
Wash the decanting and adding caps in very hot water
Remove the cotton wool from its housing and clean it with
70°alcohol
Clean the seal with hot water
Leave the lid open until the next use
Do not put back the stirrer and the plug until the next use
Operations
104
Symbols