Tylo CURVE Notice D'installation page 9

Figure 6: Circuit board
1. Electrical cable
2. Terminal for connection of electrical cable
4. Close the cover and tighten the screws (see Figure 5, Page
6).
5. Attaching the brackets to the heater see Figure 7, Page 7.
Figure 7: Attaching the brackets to the heater
6. Position the bracket screws according to the specifi ed dimen-
sioning see Figure 8, Page 7.
1
2
4
3
2
Figure 8: Dimensioning
1. 210 mm
2. 270 mm
3. 433 mm
4. 325 mm
7. Hang the heater on the screws se Figure 9, Page 7.
Figure 9: Hang the heater up.
8. Lock the heater into place with the lock screw see Figure 10,
Page 7.
Figure 10: Lock screw for bracket
7
1