Checking And Replacing The Seals; Winter Storage; Product Storage - SPM K-Soft Manuel D'utilisation

Checking and replacing the seals

BEATER AND FLANGE SEAL
The front side flange seal should be replaced
every 6 months depending on the state of wear
and the level of maintenance and lubrication.
TAP (O-RING) SEALS
The o-ring seals of the dispensing tap should be
replaced whenever they appear worn. These
seals should be lubricated each time the
appliance is reassembled after cleaning and
checked carefully in order to avoid unwanted
leaks.
SHAFT BACKSIDE SEALS
The auger backside seal has to be replaced
every time some dripping into the drawer is
evident.
Date of issue: October, 2018

Winter storage

To protect the appliance during periods of
inactivity such as winter, it is important to store
it properly as described below:
- Disconnect the appliance from the power
source.
- Dismantle, wash and sanitise all parts in
contact with the mix as described in Chapter 9.
- Also clean the exterior panels.
- Reassemble all components carefully.
- Cover the completely-reassembled appliance
with the original packaging so that it is
protected from dust and other contaminants.
- Position the appliance in a dry place.

Product storage

Since the conservation of the product used
depends on the temperature and duration of
storage, it is absolutely necessary to refer to the
instructions and specifications of the
manufacturer in order to avoid health risks due
to deterioration of the product under incorrect
conservation conditions.
Revision 1 Page 42/72