Connecting To Mains Power Supply - SPM K-Soft Manuel D'utilisation

7. CONNECTING TO MAINS POWER
SUPPLY
FOR MAINTENANCE STAFF ONLY
Before inserting the plug into the power
socket, as already explained in the
previous section, it is necessary that you
carefully read the following instructions for
your own safety:
- Make sure the connection is made to a
system with an effective earth as required
by current safety standards (fig. 3).
The manufacturer cannot be held
responsible for any damage caused by
failure to earth the system.
- Always check the electrical specifications
on the data plate of each appliance which
will always supersede those shown in this
manual.
- It is essential, for proper and safe
installation, to provide a socket controlled
by a circuit breaker with contact opening
distance equal to or greater than 3 mm, in
accordance with applicable national safety
regulations (fig. 3).
- Never use extension cables or multiple
sockets.
- Make sure that the power lead is not
crushed in any way along its full length.
- To remove the plug, having always first
disconnected the main switch, grasp the
plug and pull gently.
Important
IF THE POWER LEAD IS DAMAGED, IT MUST
BE REPLACED BY THE MANUFACTURER OR BY
ITS SERVICE CENTRE OR BY A SUITABLY-
QUALIFIED PERSON IN ORDER TO AVOID
Date of issue: October, 2018
HAZARDS.
- If required by local regulations, it is
possible to have the appliance permanently
connected to electrical power supply, ref.
National Electrical Code (NEC) and NFPA
70. If this is the case, it is necessary to
remove the right side panel, disconnect the
power cable from the machine wiring,
remove it from the machine and replace it
with the permanent cable by respecting the
local codes.
Revision 1
Fig. 3
Page 29/72