SPM K-Soft Manuel D'utilisation page 39

- Once assembled, insert the beater carefully
into the cylinder making sure that the rear
shank fits perfectly in its seat within the cylinder
(fig. 28).
- After installing the piston seals and lubricating
them as necessary (fig. 29), insert the piston
into its housing in the flange, mount the
dispensing lever together with its spring and
connect them with the fixing pin (fig. 29).
!ATTENTION!
An imperfectly fitted tap will compromise its
- Carefully lubricate the sealing gasket of the
front flange (fig. 30).
- Refit the flange so that the locating pin mates
with its seat (fig. 31).
Date of issue: October, 2018
seal.
Revision 1
Fig. 28
Fig. 29
Fig. 30
Fig. 31
Page 39/72