1. IMPORTANT WARNINGS AND
ADVICE
This operator's and installation manual is
an integral part of the appliance and
should be kept for future consultation.
Unless otherwise stated, this manual is
intended for the operator (staff using the
equipment on a daily basis) and maintainer
(staff qualified for installation and/or
maintenance). The parts of the manual
addressed only to the maintainer will be
highlighted accordingly. Carefully read the
instructions contained in this manual
before installing and using the appliance.
This appliance has been designed for the
production of soft serve ice cream and
similar products. Upon receipt of this
appliance make sure that the identification
code of the same corresponds to that
ordered by you and appearing on all
transport documents, namely:
- "appliance name" followed by the serial
number. This appliance is intended solely
for the use for which it was designed and
the manufacturer cannot be held
responsible for any damage due to
improper use.
This appliance is not intended for use by
children under 8 years old nor by persons
with reduced physical, sensory or mental
capabilities, nor those lacking experience
and knowledge, unless they have been
supervised or instructed concerning use of
the appliance by a person responsible for
their safety. Children should be supervised
to ensure that they do not play with the
appliance. Cleaning and sanitising cannot
be carried out by children if not carefully
supervised.
This appliance is not suitable for outdoor
use nor for installation in places where jets
of water can be used. This appliance must
be installed in places where it can be
inspected by qualified staff. Do not place
inflammable gas cylinders near this
appliance.
This appliance is designed for applications
such as:
-
Staff kitchen areas in shops, offices
and other working environments
Date of issue: October, 2018
-
Common areas in hotels, motels and
other residential environments
-
Bed and breakfast, catering and
similar applications
2. SUPPLIED WITH THE APPLIANCE
At the time it is opened, inside the packaging
you will find the following items:
- This Operator's manual;
- Declaration of CE Conformity
- 1 tube of lubricant (vaseline);
- 1 drip tray;
- 2 piston o-ring;
- 1 frontal flange gasket;
- 1 star shape device.
3. ADVICE FOR TRANSPORT
To prevent the oil contained in the hermetic
compressor draining into the cooling circuit, the
device must be transported, stored and handled
in the upright position, following the instructions
on the packaging. If the appliance has been
accidentally, or intentionally for reasons of
transport, held in a non-vertical position it is
necessary, before starting up, to keep it for
about 3-4 hours in an upright position so that
the oil returns to the compressor.
4. ADVICE FOR LIFTING
Each appliance is equipped with a special
wooden pallet that allows it to be moved using
the usual vehicles for handling and lifting.
Never lift the appliance alone, always seek
the help of another operator.
Revision 1
Attention
Page 26/72