SPM K-Soft Manuel D'utilisation page 35

Attention
To avoid risk of electrical shock or contact
with moving parts during dismantling and
reassembly, make sure all switches are in
the off position and that the power lead is
disconnected from the mains.
- Unscrew the security knobs and remove the
front flange (fig. 16 and 17).
- Dismantle the tap from the flange by removing
the fixing pin (fig. 18) so that you can remove
the lever and its spring and release the piston
from its housing (fig. 19).
Attention
To prevent the formation of bacteria
always remove and clean the piston o-ring
seals. Failure to comply with this
requirement poses a health hazard.
Date of issue: October, 2018 Revision 1
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Page 35/72