SPM K-Soft Manuel D'utilisation page 31

- Position the air regulation pipe and adjust it,
lifting and rotating the upper movable part in a
clockwise direction, to the closed position on the
lower notch indicated by the arrow (fig. 7).
- Pour the remaining product into the upper
tank.
- Replace the cover on the tank, insert the plug
and turn on the main switch A (fig. 8).
- Select the desired mode of operation from the
control panel (fig. 9)
- To activate the cooling system in cooling mode
push the power button B on the control panel
(fig. 9).
!ATTENTION!
On pushing the power button the cooling system
comes into operation. To prevent the appliance
being damaged, always make sure you have
already introduced the mix into the tank before
activating the cooling system. Never activate it
with the tank empty.
- To change the consistency of the mix, press
the + and – keys of the control panel (fig. 9).
Pressing + will cause the number of LEDs lit to
rise and consequently the consistency setting
increases. Pressing
number of LEDs lit and reduce the mix
consistency (fig. 11).
–
- If the key is pushed until all three
consistency LEDs go out, the appliance will go
into defrost mode. This mode will be indicated
by the fact that only the LED of the power
button B is lit.
- To activate wash mode, push the button
WASH button (button C in fig. 9) after switching
off the cooling system by pressing the power
button B and making sure that its LED is off.
Date of issue: October, 2018
– instead will decrease the
Revision 1
Fig. 7
Fig. 8
Fig. 9
Page 31/72