Stihl TS 410 Notice D'emploi page 28

English
ground or any objects. There must
not be anyone within the swivel
range of the cut-off machine
N Make sure you have a firm footing
N Press the cut-off machine firmly
against the ground, holding the
handle with your left hand, thumb
wrapped round the handle
N Place your right foot on the shroud
N Pull the starter grip slowly with your
right hand until you feel it engage –
then give it a brisk strong pull – do
not pull out the starter rope all the
way
Do not let the starter grip snap
back – it may break! Guide it
back into the housing in the
opposite direction so that it can
rewind properly.
When the engine has turned over for
the first time
4
N Set choke lever (4) to f – press the
button of the decompression valve
and continue cranking
26
Once the engine is running
N Squeeze throttle trigger fully and let
engine run at full throttle for
approx. 30 s
N When it has warmed up, set the
choke lever to e
3
N The slide control (3) moves to the
normal positionF when the throttle
trigger is squeezed
If the carburetor has been set correctly,
the cutting wheel should not rotate when
the engine is idling.
The cut-off machine is now ready for
use.
Switch off engine
3
N Slide control (3) toSTOP or 0
Additional hints on starting
If the engine does not start
The choke lever was not returned to f
in time after the engine turned over for
the first time.
N Slide control to START = starting
throttle position
N Set the choke lever to e = warm
start, even if the engine is cold
N Pull the starter rope through 10-20
times to ventilate the combustion
chamber
N Restart the engine
If the tank has been drained
completely
N Refueling
N Press the fuel pump bulb 7-10 times
– even if it is full of fuel
N Set the choke lever in accordance
with the engine temperature
N Restart the engine
TS 410, TS 420