Fueling - Stihl TS 410 Notice D'emploi

English

Fueling

Preparing the machine
N Before fueling, clean the filler cap
and the area around it so that dirt
cannot fall into the tank.
N Always position the machine so that
the filler cap is facing upwards.
Never use a tool to open the
bayonet filler cap. This could
damage the cap and cause fuel to
leak out.
Opening the filler cap
1.
2.
N Press the filler cap down as far as
possible by hand, then turn it
counterclockwise (approx. 1/8 turn)
and remove
24
Refueling
Take care not to spill fuel while fueling
and do not overfill the tank. STIHL
recommends use of the STIHL filling
system for fuel (special accessory).
Closing the filler cap
1.
2.
N Fit the cap and turn it until it
engages in the bayonet catch.
N Press the cap down as far as
possible with your hand and turn it
clockwise (approx. 1/8 of a turn)
until it engages properly
Change the fuel pick-up body every
year
N
Drain the fuel tank.
N Pull the fuel pick-up body out of the
tank with a hook and disconnect it
from the hose.
N Connect a new fuel pick-up body to
the hose.
N Return the fuel pick-up body to the
tank.
TS 410, TS 420