Stihl TS 410 Notice D'emploi page 17

Troubleshooting
Cutting wheel
Error
ragged edges or cut surfaces, crooked
cut
heavy wear on the sides of the segments Cutting wheel gyrates
ragged edges, crooked cut, no cutting
performance, generation of sparks
poor cutting performance, high segment
wear
Breakdowns or tears in the parent wheel
and segment
Undercut
1)
STIHL recommends STIHL servicing dealers
TS 410, TS 420
Cause
Deviation in radial or axial run-out
Cutting wheel is dull; built-up edges with cut-
ting wheels for stone
Cutting wheel is turning in the wrong
direction
Overloading
Cutting in the wrong material
Remedy
1)
Contact a servicing dealer
use a new cutting wheel
Sharpen cutting wheels for stone by
briefly cutting through abrasive materials;
replace cutting wheel for asphalt with a
new one
Mount cutting wheel so that it turns in the
right direction
use a new cutting wheel
use new cutting wheel; observe separat-
ing layers of various materials
English
15