Assembling The Cast Arm And Guard - Stihl TS 410 Notice D'emploi

1
3
2
1 Button (+):
activate the electronic water control
or increase water flow to cutting
wheel
2 Button (–):
activate the electronic water control
or decrease water flow to cutting
wheel
3 Deactivate electronic water control;
no water is fed to the cutting wheel
Using the Electronic Water Control
N Start engine, see
"Starting / Stopping the Engine"
N Blip the (+) button or (–) button with
the thumb of the right hand – the
right hand always remains on the
rear handle while doing so, the left
hand always remains on the
handlebar – no water is fed to the
cutting wheel yet during idling
During use, the set amount of water is
fed to the cutting wheel.
N Adjust water flow if necessary – to
do so, blip the (+) button or (–)
button with the thumb of the right
hand until the correct water quantity
is attained – the right hand always
TS 410, TS 420
remains on the rear handle while
doing so, the left hand always
remains on the handlebar
If the cutoff-machine is idling after use,
no more water will be fed to the cutting
wheel – the electronic water control,
however, remains activated.
With continued use, the last quantity of
water set will be fed to the cutting wheel
again automatically.
Maintenance and Care
If too little water or no water is fed to the
cutting wheel during use although the
electronic water control has been
activated:
1 2
N Remove the coupling sleeve (1)
N Unscrew "water connection with
screen" (2) and rinse under running
water – the screen remains on the
water connection
Assembling the cast arm
and guard
The "cast arm with guard" is mounted on
the inboard side by the manufacturer.
The "cast arm with guard" can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance.
Outboard mounting
N Disassemble the cutting wheel (see
"Fitting / replacing an cutting wheel")
Remove water attachment
1
2
N Unscrew the banjo bolt (1) with the
combination wrench – in the
process, remove the square nut
from the inside of the guard from the
guide
N Remove the water hose (2) with
connector from the adjusting
lever (3)
N
Pull the water hose (2) out of the
guide (arrows) in the V-belt guard
English
3
1
17