Electronic Water Control - Stihl TS 410 Notice D'emploi

English
Undercut
Do not cut into the base course
(frequently chipped stones and gravel)
when cutting roadway pavement –
cutting in chipped stones and gravel is
revealed by light-colored dust –
excessive undercut may occur as a
result – Danger of shattering!
Built-up edges, sharpen
Built-up edges take the form of a light
gray deposit on the tops of the diamond
segments. This deposit on the segments
clogs the diamonds and blunts the
segments.
Built-up edges can form:
16
– when cutting extremely hard
materials, e. g., granite
– with incorrect handling, e. g.,
excessive feed effort
– if excessively large cross-sections
are cut without pendulum cutting
(movement back and forth in the
cutting plane)
Built-up edges increase vibration,
reduce cutting performance, and cause
formation of sparks.
At the first signs of built-up edges,
immediately "sharpen" the diamond
cutting wheel – to do this, briefly cut
through abrasive material such as
sandstone, aerated concrete or asphalt.
Addition of water prevents the formation
of built-up edges.
If work continues with dull segments,
these may soften due to the high heat
generated – the parent wheel is
annealed and its strength is
compromised – this can lead to stresses
that are clearly recognizable by
gyrations of the cutting wheel. Do not
continue to use the cutting wheel – Risk
of accident!

Electronic water control

The cut-off machines STIHL TS 410,
420 can be equipped with an electronic
water control.
The electronic water control makes it
possible to feed the optimum amount of
water to the cutting wheel. No water is
fed to the cutting wheel during idling.
Before starting work
N Familiarize yourself with the
sequence of motions while the
engine is switched off
N All of the control panel buttons can
be operated with the thumb of the
right hand – the right hand always
remains on the rear handle while
doing so
N The left hand always remains on the
handlebar
Control Panel
When the engine is running, it is
possible to activate / deactivate the
electronic water control and adjust the
water flow.
TS 410, TS 420