Reading The Running Hours Counter; Care And Maintenance - Tractel tirak MWX 500-1537 Série Manuel D'installation

Installation and operating manual
250 running hours for devices with 12 or 18 m/min rope
speeds
500 running hours for devices with a rope speed of 9 m/min
or less
10 years after manufacture
If a general overhaul has been carried out then the period com-
mences anew.
A general overhaul of the hoist must only to be undertaken by
TRACTEL Greifzug GmbH or a hoisting gear workshop that has
been approved by TRACTEL Greifzug GmbH.
Contact TRACTEL Greifzug GmbH or your supplier with regards
to this test.
Exceptional tests
After an emergency descent, the hoist must always be tested in
manual mode by TRACTEL Greifzug GmbH or a hoisting gear
workshop that has been authorized by TRACTEL Greifzug
GmbH (see '10.5 Emergency descent' on page 18).
Any damaged or worn part found must always be replaced.

15.3 Reading the running hours counter

The running hours counter is located in the hoist's terminal box.
The running hours counter counts the time in which the hoist is in
operation as running hours (UPWARD or DOWNWARD move-
ments).
DANGER!
Danger of death due to electric shock!
– Disconnect the hoist from the power supply by pulling out
the plug.
– Pull out the power plug.
– Open the terminal box.
– Read the running hours counter:
– Note the running hours in the logbook.
– Close the terminal box.

15.4 Care and maintenance

Interval Work
Daily
– Check the anchorage of the
hoist
– Inspect the rope for clinging
dirt
Weekly
– Check the rope, see page 22
– Check the connecting cable
and control cable
EN-22
Interval
1 x annually –
250 / 500
1)
Running
hours / after
10 years
Whenever
necessary
Devices with 12 or 18 m/min rope speed
1)
Devices with a rope speed of 9 m/min or less
2)
Depending upon which occurs first
3)
Rope
Risk of injury through stabs and cuts!
Broken wires in the wire rope can result in protruding wires!
Protruding wires can cut or stab through safety gloves!
– Wear suitable leather protective gloves when working
with wire ropes.
– Never let the wire rope run through your hands.
Cleaning
Brush the dirt off soiled ropes when dry if necessary. Re-lubricate
as necessary.
Use the brush attachments to clean the rope at the hoist in an
extremely dirty environment.
Implementation
Operating person-
nel
Operating person-
nel
Work
Hoist safety inspection
General overhaul of the hoist TRACTEL Greifzug
2)
–
3)
See page 22:
– Clean the rope
– Lubricate the rope
– Replace the rope
– Clean the rope reel and rope
guide
– Clean the limit switch and
the activator
– Lubricate the limit switch
activator
– Replace the cable
DANGER!
Implementation
Authorized mainte-
nance personnel
GmbH or a hoisting
gear workshop that
has been approved
by TRACTEL
Greifzug GmbH
Trained person
nominated by the
operator
Electrician
G961.1 - 03/2012