System Manufacturer's Responsibilities; Overview; Delivery State; Scope Of Delivery - Tractel tirak MWX 500-1537 Série Manuel D'installation

– Adhere to the permitted temperature range, see Table 1 on
page II.
2.3 System manufacturer's responsibili-
ties
– The system manufacturer is responsible for the design,
manufacture, assembly and marketing as well as obtaining
the CE seal of approval and issuing the EU Declaration of
Conformity.
– The products contained in the package supplied by TRAC-
TEL Greifzug GmbH must be carefully selected by the sys-
tem manufacturer, be used in the approved manner and in-
stalled in compliance with the instructions given in this in-
stallation and operation manual.
– The information and notes contained in this installation and
operating manual must be integrated into the system manu-
facturer's operating manuals and documentation and sup-
plemented by the addition of system specific details (e.g.
blockages and malfunction procedures). Merely handing this
manual over to the operator is insufficient.
– If necessary, a test report must be included, in which the
static and dynamic tests that were run are described in de-
tail.
– Instructions regarding the maintenance of the product and
its accessories must be integrated in the system's mainte-
nance manual.
3

Overview

3.1

Delivery state

The equipment is delivered fully assembled.
3.2

Scope of delivery

Hoist with control and connecting cable (wired fixed) in
accordance with the order specifications
tirak wire rope in accordance with the order specifications
TM
Support frame
Free reeler or driven reeler in accordance with the order
specifications
Original Installation and operating manual
Circuit diagram
Logbook
Test certificate
CE Declaration of Conformity
Limit switch for switching off the lifting and pulling motions in
accordance with the order specifications.
G961.1 - 03/2012
Optional scope of delivery
Button panel, pluggable
Central control unit, pluggable
Electronic or mechanical load limiting device
Deflection roller
Brush attachments for cleaning the ropes
Swivel pulley
Remote control with joystick
Switching cabinet (optional for hoists with converter)
Secondary brake blocstop™ BSO
The lengths of the control cable and the connecting cable are
determined when ordering. See also '6 Optional accessories' on
page 11, '7 Options' on page 11 and 'Electrical connection' on
page 12.
3.3

Equipment description

Authorized utilization
Hoist
The hoists are designed for raising and lowering as well as pull-
ing and releasing or moving loads.
The product may only be utilized for material transportation.
Its use for transporting personnel is prohibited.
Never use ropes that are not the specified original ropes appro-
ved for the application. Abide by the details about the rope type
and diameter.
Product purpose
The product is intended for commercial as well as private use.
The precise intended use will be defined by the operator or the
equipment manufacturer.
Swivel pulleys, hooks, shackles and eyes and other optional
carrying devices belonging to the product are only to be used
together with this product.
If the load cannot be guided by on-site means then a rotation-
resistant wire rope with a swivel hook or a rope swivel must be
used. Swivel hook and rope swivel must turn freely when sub-
jected to loads.
Maintenance and repair work must only be undertaken by author-
ized service personnel, see '15.1 Authorized maintenance per-
sonnel' on page 21.
Health and safety requirements
TRACTEL Greifzug GmbH declares that the machine described
in this instruction manual complies with technological safety
standards that were applicable to the equipment in the European
Union when it was launched on the market by the manufacturer.
Test reports (test certificates) are included with the product. The
static and the dynamic tests are described in detail in the test
reports.
Installation and operating manual
EN-5